Our Services

After the Engines/Generators are delivered to our Service Center, the form with a sample photo is filled out below. In this form, all electrical measurements of the motors / generators are made in detail and recorded. Measurements are made with a periodically calibrated specification (megger, DC resistance device ... etc.). This expertise is carried out by our expert staff to show our customers if there are any electrical problems are made. After filling out the form for each engine /generator, our customers are informed by e-mail along with their photos.

After the Engines/Generators are delivered to our Service Center, the form with a sample photo is filled out below. In this form, all electrical measurements of the motors / generators are made in detail and recorded. Measurements are made with a periodically calibrated specification (megger, DC resistance device ... etc.). This expertise is carried out by our expert staff to show our customers if there are any electrical problems are made. After filling out the form for each engine /generator, our customers are informed by e-mail along with their photos.

Hot water and special solvents in our washing & dyeing cabin for engines/generators measuring 4mx4mx4m whose inspections have been completed with its help, it is thoroughly cleaned. Dust, dirt and/or external chemicals that may come from production, especially on engines/generators working in heavy industry over time in particular, it sticks to the windings, causing the insulation to fall off over time and causing damage to the windings over time. December order to prevent stops that may occur except for planned stops, the engine / generators should be washed and cleaned at regular intervals we recommend it.

After cleaning the Motor & Generator windings with hot water cannons and special solvents, PID sizes of 4mx4mx3m are controlled drying is provided in our oven.

After measuring the insulation of the windings coming out of the oven with a megger, they are varnished with an Immersion Varnish System An immersion varnish system is used for varnishing the windings, and oven varnish of appropriate properties is used. After the dipping varnishing process, the windings are baked again in a PID-Controlled oven.

For maintenance or winding, turning of the collectors of the incoming ring motor or generator and DC motors is carried out. After the turning process of the collectors, decoupage of the slices is provided with the help of a special machine with air. After the intermediate decking process is completed, the chamfer is broken to ensure that no damage to the coals is caused during operation.

All engines & generators that come for maintenance or repair are necessarily taken with rotor balancing equipment. The form containing the previous and next values in the form shown below is sent to our customers.

After the completion of the operations of the Engines & Generators; to see how correctly the work done is done, static and it is necessary to conduct dynamic tests. We can summarize the Static Tests as follows.
* Insulation level measurement (megger)
* measurement of winding internal resistance with an accuracy of 0.01% (DC Resistance)
* PT100 PTC RTD ..measurement of vs sensors
* Hi-Pot (High Voltage Withstanding Test) and Surge (Spir Short Circuit Test)
* Adjusting the Neutral Axis october DC Motors
* We can summarize the Dynamic Tests as follows.
* Idle rotation at rated voltage and speed
* Recording of voltage and drawn current.
* Performing vibration analysis while the engine is running
* Observation of heat increase with a Thermal Imager
* Bearing or any mechanical sound control

To make the engines that are not found to have problems in the tests suitable for the shipment by painting them with protection paint in their original color. We are also able to work with our customers if they submit special requests about the paint.